Although the Corrugating process has a multitude of critical process points in order to manufacture a quality corrugated sheet, there are some of us that know from experience that the curing process is the most important of all. The ability to evenly distribute the pressure and BTU’s through the board in the time required for the next step of the process will determine if you will be successful or not.
The SIMON S-Press is the most cost effective and maintenance friendly system with the ability to adapt to any corrugator new or old. The technical support is top shelf and will assist you, not merely support in any project small or large. I also appreciated the industry knowledge that came with the technical support which provided unbiased oversight of the operation with a collaborative effort. The SIMON S-Press process controls are very simple and effective. The technical support assisted us with the integration of our existing system and was open to our own thought process during the installation. This was priceless! The SIMON S-Press had the answer for us when we were struggling on a new machine that ran predominately down warp at very slow rates and immediately after installing the SIMON SPress, provided us our ability to run flat sheets at any rate of speed. E, B, C, I, EB, BC and so on… The substrates also were affected positively providing us with more flexibility and run ability. The SIMON S-Press gave us the ability thereafter to run flat well bonded BC Double wall at 300 Meters a minute! This, I have never personally accomplished before and would have never been able to do on this particular machine without the S-Press. Previous to the install of the S-Press, our customers also complained of post warp and moisture in trailers but this vanished with accolades from all of our sites. I highly recommend the SIMON S-Press and will be purchasing another system very shortly on my next project!